| 41 |
|
Temperature and Strain Rate Effects on Tensile Strength and Inelastic Constitutive Relationship of Sn-Pb Solders/
|
Nose, H
|
American Society of Mechanical Engineers
|
2003
|
|
|
|
| 42 |
|
Temperature Distribution in Advanced Power Electronics Systems and the Effect of Phase Change Materials on Temperature Suppression During Power Pulses/
|
Evans, A G
|
American Society of Mechanical Engineers
|
2001
|
|
|
|
| 43 |
|
Temperature Estimation and Life Prediction of Turbine Blades Using Post-Service Oxidation Measurements
|
Swaminathan, V. P
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 44 |
|
Temperature Measurement of Workpiece in Surface Grinding by PVD Film Method
|
Kato, T
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 45 |
|
Temperature Measurements of a Transient Thermal Plume in a Confined Space
|
Hsu, C.-H
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 46 |
|
Tensile Failure of Stainless-Steel Notched Bars Under Hydrogen Charging
|
Valiente, A
|
American Society of Mechanical Engineers
|
1993
|
|
|
|
| 47 |
|
Tensile Strengths for Laser-Fabricated Parts and Similarity Parameters for Rapid Manufacturing/
|
Kahlen, Franz-Josef
|
American Society of Mechanical Engineers
|
2001
|
|
|
|
| 48 |
|
Tension and Speed Regulation for Axially Moving Materials/
|
Nagarkatti, Siddharth P
|
American Society of Mechanical Engineers
|
2000
|
|
|
|
| 49 |
|
Testing Three-Dimensional Bluff-Body Models in a Low-Speed Two-Dimensional Adaptive Wall Test Section
|
Sumner, D
|
American Society of Mechanical Engineers
|
1995
|
|
|
|
| 50 |
|
Test Results for PTFE-Faced Thrust Pads, With Direct Comparison Against Babbitt-Faced Pads and Correlation With Analysis/
|
Ettles, C. M
|
American Society of Mechanical Engineers
|
2003
|
|
|
|
| 51 |
|
Test Results of a New Damper Seal for Vibration Reduction in Turbomachinery
|
Vance, J. M
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 52 |
|
Theoretical Analysis of the Maximum Heat Transport in Triangular Grooves: A Study of Idealized Micro Heat Pipes
|
Peterson, G. P
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 53 |
|
Theoretical Analysis of Transitional and Partial Cavity Instabilities/
|
Watanabe, Satoshi
|
American Society of Mechanical Engineers
|
2001
|
|
|
|
| 54 |
|
Theoretical and Experimental Comparisons for Damping Coefficients of a Short-Length Open-End Squeeze Film Damper
|
San Andres, L. A
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 55 |
|
Theoretical and Experimental Evaluation of the Bond Strength Under Peeling Loads
|
Nayeb-Hashemi, H
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 56 |
|
Theoretical and Experimental Studies on the Pseudo-Dropwise Condensationof a Binary Vapor Mixture
|
Hijikata, K
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 57 |
|
Theoretical and Experimental Study of Development of Two-Dimensional Steady and Unsteady Wakes Within Curved Channels
|
Schobeiri, M. T
|
American Society of Mechanical Engineers
|
1995
|
|
|
|
| 58 |
|
Theoretical and Experimental Study of Electrohydrodynamic Heat Transfer Enhancement Through Wire-Plate Corona Discharge
|
Owsenek, B. L
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 59 |
|
Theoretical Performance of a Solar Pond With Enhanced Ground Energy Storage
|
Prasad, R
|
American Society of Mechanical Engineers
|
1980
|
|
|
|
| 60 |
|
Theoretical Study of Pressure Fluctuations Downstream of a Diffuser PumpImpeller-Part 1: Fundamental Analysis on Rotor-Stator Interaction
|
Qin, W
|
American Society of Mechanical Engineers
|
1993
|
|
|
|